Dear List,
I still do not understand how to call the .cal files... I was trying to
calculate a View matrix using the following command:
*cat ./Workplanes/Floor.pts | rcontrib -n 1 -f klems_int.cal -b kbin(0, 1,
0, 0, 0, 1) -bn Nkbins -m window_1 -I+ V_model.oct > ./VMX/V-Room-1.vmx*
···
*
*
The problem is in the *kbin(0, 1, 0, 0, 0, 1)* part, which I do not know
how to call (this is a window looking south).
I know I could call it like kbinS; but since I am exporting from SketchUp,
the normals and Ups may vary.
THANKS VERY MUCH
German
German,
I think you need to enclose the kbin in single quotes like this:
-b 'kbin(0,1,0,0,0,1)'
Andy
···
On Wed, Mar 20, 2013 at 3:51 PM, Germán Molina Larrain <gmolina1@uc.cl>wrote:
Dear List,
I still do not understand how to call the .cal files... I was trying to
calculate a View matrix using the following command:
*cat ./Workplanes/Floor.pts | rcontrib -n 1 -f klems_int.cal -b kbin(0,
1, 0, 0, 0, 1) -bn Nkbins -m window_1 -I+ V_model.oct > ./VMX/V-Room-1.vmx
*
*
*
The problem is in the *kbin(0, 1, 0, 0, 0, 1)* part, which I do not know
how to call (this is a window looking south).
I know I could call it like kbinS; but since I am exporting from SketchUp,
the normals and Ups may vary.
THANKS VERY MUCH
German
_______________________________________________
Radiance-general mailing list
Radiance-general@radiance-online.org
http://www.radiance-online.org/mailman/listinfo/radiance-general