Thanks Thomas. I will definitely try it. Ecotect I think reports only the
values, it saves it with the extension ".ok", but I will double check.
However, it will fall in the right location on the 3D model, so I think it
is checked against the grid information.
···
On Thu, Jun 26, 2014 at 4:18 PM, Thomas Bleicher <[email protected]> wrote:
Su2rad has that feature but it may be disabled in the official version.
You just need to remove a few comments in the loader file to get it
working. In which format does Ecotect report the values? Just values or
coordinates and values?Ery Mailing-List <[email protected]> wrote:
Folks
I have this question for a long time and have asked it to a number of
people with a negative answer, and I can't remember if I have asked the
forum, but here it goes: is there a way that we can import the illuminance
contour back to SketchUp?We use SketchUp as the interface to Radiance, but the missing piece that
we missed from Ecotect is the ability to import back the illuminance values
on the grid back into the 3D model, so that the contour can be put into the
3D context.Thanks
Ery
------------------------------
Radiance-general mailing list
[email protected]
http://www.radiance-online.org/mailman/listinfo/radiance-general--
Sent from my Android phone with K-9 Mail. Please excuse my brevity.