Apologies, it is actually working with the settings below.
I think the results from when it wasn’t working for some reason weren’t being superseded.
Re-exporting the SketchUp model resolved this.
Senior Sustainability & Energy Engineer
T: 01865 864500
CBG Consultants Ltd Registered No. 538 4147/VAT Registration No. 860 3120 63
Please consider the environment - do you really need to print this email?
The views expressed in this e-mail are those of the sender and not necessarily those of CBG Consultants.
The content of this email is private and may be confidential for the intended recipient only. If misdirected, please notify us by telephone and confirm that it has been deleted from your system and any copies destroyed. If you are not the intended recipient you are strictly prohibited from using, printing, copying, distributing or disseminating this e-mail or any information contained in it.
We use reasonable endeavours to virus scan all e-mails leaving the company but no warranty is given that this e-mail and any attachments are virus free. You should undertake your own virus checking. The right to monitor e-mail communications through our networks is reserved by us.
From: Thompson, Ross
Sent: 16 July 2014 10:52
To: [email protected]
Subject: DAYSIM: 0% Daylight Factor across all points [Filed 16 Jul 2014 10:52]
I have previously used DAYSIM to produce some calculations. However the results are no longer repeatable.
Despite getting values for UDI and DA etc. all the daylight factors are now 0.
My suspicion is that the DAYSIM installation has clashed with a RADIANCE installation and the system paths are confused.
I have tried uninstalling everything and just reinstalling Daysim 3.1e.
This produces the following system paths:
As C:\Daysim\lib is in RAYPATH, I can’t see what is causing the problem
Thanks for your help